Size : 10mg
Phone : +1 850 650 7790
Synonyms: MH 12-43, L593754
| Description | EIPA (L593754) is a TRPP3 channel inhibitor (IC50=10.5 μM) and an inhibitor of Na+/H+ exchange (NHE). EIPA inhibits megacytosis, promotes autophagy, and can be used in inflammation and tumor studies. |
| Targets & IC50 | TRPP3 channel:10.5 μM |
| In vitro | METHODS: Ten cells were pretreated with EIPA (50 µM) for 1.5 h. Dextran index was measured by Dextran uptake assay. RESULTS: Immortalized but untransformed hTERT-HME1 mammary epithelial cells and MCF10A cells did not exhibit megacellular drinking in complete medium, but stimulated dextran uptake by nutrient deprivation. Although PIK3CB was found to be required for growth factor-stimulated macrocytosis, oncogenic mutations in PIK3CA were sufficient to induce constitutive macrocytosis in mouse embryonic fibroblast MEFs and untransformed MCF10A cells. [1] METHODS: MKN28 cells were treated with EIPA (5-100 µM) for 48 h. Cell proliferation was detected by cell count. RESULTS: Cell exposure to EIPA inhibited the proliferation of MKN28 cells in a dose- and time-dependent manner. [2] |
| In vivo | METHODS: To assay in vivo activity, EIPA (10 mg/kg) was injected intraperitoneally into BALB/c mice bearing 4T1 xenografts, and 70 kD FITC-Ficoll was injected into the tumors 1 h later. The mice were necropsied 1 h after Ficoll injection, and the tumors were excised and frozen in OCT. RESULTS: EIPA-sensitive 70 kD FITC-Ficoll uptake was observed in in situ homozygous 4T1 tumors of BALB/c mice, suggesting that AMPK activation or other signals are sufficient to trigger the formation of large fusions in vivo. [1] |
| Synonyms | MH 12-43, L593754 |
| Cell Research | The effect of EIPA alone (without alanine or proline) is also examined in both control (DMEM cultured cells) and amino acid-starved cells. The cells are incubated for 6 h in DMEM containing 5% FBS and either 0 or 0.3 mM EIPA (labeled QNN and QNE, respectively), HBSS containing either 0 or 0.3 mM EIPA (labeled HNN and HNE, respectively), HBSS with 1.0 mM alanine (labeled HAN) or 0.5 mM proline (labeled HPN), HBSS with 1.0 mM alanine and 0.3 mM EIPA (labeled HAE), and HBSS with 0.5 mM proline and 0.3 mM EIPA (labeled HPE) [2]. |
| Molecular Weight | 299.76 |
| Formula | C11H18ClN7O |
| Cas No. | 1154-25-2 |
| Smiles | CCN(C(C)C)c1nc(N)c(nc1Cl)C(=O)NC(N)=N |
| Relative Density. | 1.49 g/cm3 |
| Storage | Keep away from moisture,Keep away from direct sunlight,Store at low temperature Powder: -20°C for 3 years | In solvent: -80°C for 1 year Shipping with blue ice/Shipping at ambient temperature. | |||||||||||||||||||||||||||||||||||
| Solubility Information | DMSO: 30 mg/mL (100.08 mM), Sonication is recommended.  | |||||||||||||||||||||||||||||||||||
| In Vivo Formulation | 10% DMSO+40% PEG300+5% Tween 80+45% Saline: 4 mg/mL (13.34 mM), Sonication is recommended. Please add the solvents sequentially, clarifying the solution as much as possible before adding the next one. Dissolve by heating and/or sonication if necessary. Working solution is recommended to be prepared and used immediately. The formulation provided above is for reference purposes only. In vivo formulations may vary and should be modified based on specific experimental conditions. | |||||||||||||||||||||||||||||||||||
Solution Preparation Table | ||||||||||||||||||||||||||||||||||||
DMSO
Note : The dilution table applies only to solid products. For liquid products, please calculate the stock solution based on the stated concentration and/or density. | ||||||||||||||||||||||||||||||||||||
For example, if the intended dosage is 10 mg/kg for animals weighing 20 g , with a dosing volume of 100 μL per animal, and a total of 10 animals are to be administered, using a formulation of 
10% DMSO+ 40% PEG300+ 5% Tween 80+ 45% Saline/PBS/ddH2O , the resulting working solution concentration would be 2 mg/mL.Dissolve 2 mg of the compound in 100 μL DMSO to obtain a stock solution at a concentration of 20 mg/mL . If the required concentration exceeds the compound's known solubility, please contact us for technical support before proceeding.
1) Add 100 μL of the DMSO stock solution to 400 µL PEG300 and mix thoroughly until the solution becomes clear.
2) Add 50 µL Tween 80 and mix well until fully clarified.
3) Add 450 µL Saline,PBS or ddH2O and mix thoroughly until a homogeneous solution is obtained.
| Size | Quantity | Unit Price | Amount | Operation |
|---|
